EIGRP通过（）来判定原有的neighbor是否变为dead状态。A、UnicastB、Hold TimeC、MulticastD、Broadcast

相关问题 1：

Which two MBGP IPv4 sub－AFIs does the JUNOS software support?()A.unicastB.anycastC.multicastD.broadcast

点击查看答案

相关问题 2：

When troubleshooting an EIGRP connectivity problem, you notice that two connected EIGRP routers are not becoming EIGRP neighbors. A ping between the two routers was successful.What is the next thing that should be checked?（）A. Verify that the EIGRP hello and hold timers match exactly.B. Verify that EIGRP broadcast packets are not being dropped between the two routers with the show ip EIGRP peer command.C. Verify that EIGRP broadcast packets are not being dropped between the two routers with the show ip EIGRP traffic command.D. Verify that EIGRP is enabled for the appropriate networks on the local and neighboring router.

点击查看答案

相关问题 3：

Which EIGRP packet statement is true?()A. Update packets route reliable change information only to the affected routers.B. Reply packets are multicast to IP address 224.0.0.10 using RTP.C. On high - speed links, hello packets are broadcast every 5 seconds for neighbor discovery.D. Reply packets are used to send routing updates.E. On low - speed links, hello packets are broa dcast every 15 seconds for neighbor discovery.

点击查看答案

相关问题 4：

Under which circumstance, ie network type, would an OSPF router establish a neighbor adjacency, even though the DR／BDR election process was not performed?()A. Point-to-pointB. Broadcast multicastC. Nonbroadcast multicastD. Backbone area 0E. Virtual Link

点击查看答案

相关问题 5：

What parameters must you specify when you enable EIGRP routing?()A. The broadcast address, and AS numberB. The network number and AS numberC. EIGRP routing, network number and passive interfaceD. EIGRP routing, network number, and AS

点击查看答案

相关问题 6：

What is known as "one－to－nearest" addressing in IPv6?()A. global unicastB. anycastC. multicastD. unspecified address

点击查看答案

相关问题 7：

Which three statements about EIGRP are true?()A.EIGRP converges fast RIP because of DUAL and backup routes that are stored in the topology table.B.EIGRP uses a hello protocol to establish neighbor relationshipsC.EIGRP uses split horizon and reverse poisoning to avoid routing loops.D.EIGRP uses periodic updates to exchange routing informationE.EIGRP allows routers of different manufacturers to interoperateF.EIGRP supports VLSM and authentication for routing updates.G. EIGRP use a broadcast address to send routing information.

点击查看答案